Controller Based WLANs

How to find out the AP's uplink from the controller, for the dual ethernet Aps?

by on ‎07-04-2014 11:12 AM

Environment  :  This article applies to all Aruba controllers and Aruba OS versions 3.2.x and above.

 

If we are not sure of the uplink used in dual Ethernet port aps, below command will give us the  information of which port is in active state.
 
 (Aruba) #show ap debug system-status ap-name 9c:1c:12:c2:77:46 | begin "Slave bonding info"
 
Slave bonding info
------------------
SlaveId  Name  Link  State    #LinkFails
-------      ----         ----    -----         ----------
0             eth0      UP    ACTIVE        0                                                       // Ethernet 0 is active here.
1             eth1    DOWN  STANDBY   0
 
(Aruba) #show ap debug system-status ap-name 9c:1c:12:c2:77:46 | begin "Slave bonding info"
 
Slave bonding info
------------------
SlaveId  Name  Link      State    #LinkFails
-------      ----        ----         -----        ----------
  0           eth0     DOWN  STANDBY  0                                                  
  1           eth1     UP         ACTIVE       0                                                       // Ethernet 1 is active here.

Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.