Controller Based WLANs

Answer

How to reset the packet-capture Enabled on the controller.
 

• Once the packet capture is enabled on the controller it will start capturing the packets and if you want to stop the capture and start it again it will still contain the capture it was taken before. So if you want to clear the old entry and start the session new ,please use the following command to reset the capture and start from first.

Command to reset
===============
 
#packet-capture reset-pcap controlpath-pcap
#packet-capture reset-pcap datapath-pcap
 
 
 To view the packet capture
========================
# show packet-capture controlpath-pcap
# show packet-capture datapath-pcap