Controller Based WLANs

What MIBs can be used to show information about the users and stations connected to the controller?

by on ‎07-09-2014 02:15 PM

Product and Software: This article applies to all Aruba controllers and ArubaOS versions. 

To show the total number of Associated Users, use this MIB: 
.1.3.6.1.4.1.14823.2.2.1.1.3.2.0 

The CLI equivalent is the “show datapath station counters” command. 

To show the total number of Authenticated Users, use this MIB: 
snmpwalk -v 2c -m ALL -c <snmp community name> <controller IP addr> 
.1.3.6.1.4.1.14823.2.2.1.1.2.1 | grep '<authenticated user-role name>' | wc -l 

The CLI equivalent is the “show user-table role <authenticated user-role name>” command. 

Product and Software: This article applies to all Aruba controllers and ArubaOS versions. 

To show the total number of Associated Users, use this MIB: 
.1.3.6.1.4.1.14823.2.2.1.1.3.2.0 

The CLI equivalent is the “show datapath station counters” command. 

To show the total number of Authenticated Users, use this MIB: 
snmpwalk -v 2c -m ALL -c <snmp community name> <controller IP addr> 
.1.3.6.1.4.1.14823.2.2.1.1.2.1 | grep '<authenticated user-role name>' | wc -l 

The CLI equivalent is the “show user-table role <authenticated user-role name>” command. 

To display the MAC address, user name, user role, up time, authentication method, associated AP location ID, RADIUS server, connected VLAN, connected slot, and connected port for a given wireless station IP address, use this MIB: 
snmpwalk -v 2c -m ALL -c <snmp community name> <controller IP addr> 
.1.3.6.1.4.1.14823.2.2.1.1.2.1.1 | grep '<wireless station ip address>' 

The CLI equivalent is the “show user-table verbose” command. 

To display the signal-to-noise ratio according to its associated access point for a given wireless station MAC address in decimal format "a.b.c.d.e.f", use this MIB: 
snmpwalk -v 2c -m ALL -c <snmp community name> <controller IP addr> .1.3.6.1.4.1.14823.2.2.1.1.2.2.1.7.<station mac address in decimal 
format> 

The CLI equivalent is the “show ap status <ap ip address>” command. The results will return the associated access point's BSSID in decimal format with SNR value shown as "INTEGER: X". Many access points can be displayed if the wireless station was roaming. 

Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.