Controller Based WLANs

What is the command to see if there is any faults in an Aruba Controller.

by ‎07-28-2015 09:27 AM - edited ‎07-28-2015 09:27 AM
Q:

What is the command to see if there is any faults in an Aruba Controller?



A:
The command in the below screen shot will tell us what are the active faults that occurred in an Aruba Controller.

The output that is shown in above screen shot shows that active faults.
Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.