Controller-less WLANs

Eth1 bridging in Instant AP

by ‎05-20-2016 10:22 AM - edited ‎05-20-2016 10:22 AM
Q:

 How to enable bridging in the eth1 port of Instant AP?  



A:

When the Instant AP operates as Mesh Point to make eth0 operate in bridge mode then we can enable enet0-bridging.

In order to make the eth1 port in the bridge mode, we need to either use default wired profile or wired port should be configured as downlink.

Note: If it is mesh point, we should not use eth1 as uplink as ethernet has higher priority than mesh and this works when both eth1 and mesh operates as uplink.

Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.