Controller-less WLANs

Static and ARM assigned channel and power In Instant AP
Q:

How to set static power and then allow ARM assigned channel and power in Instant AP from Command line interface?



A:

Using the  below commands, we can set static power and channel in Instant AP in a and g-band.

a-channel                          static 5 GHz channel and power... set it to 0 for ARM assigned
g-channel                          static 2.4 GHz channel and power... set it to 0 for ARM assigned

 

Set the static power and channel as below:

a-channel 40 15
g-channel 11 12

 

To set the power assigned by ARM then we need to set it to 0 as below:

a-channel 0 0
g-channel 0 0

 

Note: This is AP specific configuration.

Version History
Revision #:
2 of 2
Last update:
‎05-20-2016 10:23 AM
Updated by:
 
Labels (1)
Contributors
Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.