Why DRP config is not pushed to IAP when its enabled through Aruba Central?

Aruba Employee
Q:

Why DRP config is not pushed to IAP when its enabled through Aruba Central?



A:

We could see config error in the central when DRP config is pushed through Aruba Central as shown below:

 

DRP is enabled through Central:

 

  

 

Config error which is highlighted below:

 

In the IAP CLI we can see the DRP config is not pushed as shown below:

 

Master IP Address   *:192.168.134.18

IP Address           :192.168.134.18

Netmask              :255.255.254.0

Gateway              :192.168.134.1

NameServer           :192.168.39.180

NameServer           :192.168.39.6

DNSDomain            :ki.com

Master Key           :0349b686017b0cdb94e1e6a7677e0235a27f5d697f79f3c760

Elected Time         :1m:59s

Dynamic Radius Proxy :disable   <===========================

NTP Server           :120.88.46.10

Configuration Dirty  :disable

Allow New APs        :enable

Classification       :disable

Wireless Containment :disable

 

Solution:

 

To resolved this issue, its required to disable DRP first and remove VC IP address.

Configure with different VC IP and enabled DRP which will fix this issue.

If the VC IP address is assigned to other device my mistake, the config cannot be pushed from the Aruba Central.

 

After assigning new VC Ip address there is no config error as shown below:

 

 

 

 

Version history
Revision #:
2 of 2
Last update:
‎05-17-2016 04:04 PM
Updated by:
 
Labels (1)
Contributors
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.