Hey all,
Looking for a little clarification on the new software that allows you to configure AP's as IAP, RAP, CAP. Can I upgrade my controller to 6.5.2 and convert an old controller based AP-205 or AP-225 to an IAP to make it controllerless based? Or is this only available with newer AP models? Any insight would be appreciated.
Thanks,
Mike
You cannot, any pre-UAP APs (currently anything NOT the 203/303, and 365), if it's an AP-XXX, it will ONLY do controller termination.
Thank you
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.