Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
10-08-2014 06:52 AM
Anyway to push the radio settings via templates in Airwave to IAP-1x4 through managed mode
For the life of me I cannot figure this out.
Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACCA
[If you found my post helpful, please give kudos!]
ACDX #420 | ACCA
[If you found my post helpful, please give kudos!]
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
10-09-2014 12:22 PM
seems like there is no way, you must change the value on the AP itself within Airwave but have the AP in managed/mode as well as the VC in managed mode for the setting to be pushed.
Cannot from a template but until I get confirmation I am unsure
Cannot from a template but until I get confirmation I am unsure
Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACCA
[If you found my post helpful, please give kudos!]
ACDX #420 | ACCA
[If you found my post helpful, please give kudos!]
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator