- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
05-18-2016 02:53 AM
Hi
I have an Aruba IAP275 setup for site surveys. It's powered by an industrial POE switch and powers up fine. The only problem is that I need to physically connect a device to the switch or the AP keeps rebooting itself. Is this normal behavior?
Is there a way to prevent the AP from rebooting itself every few minutes when the Ethernet port isn't connected?
Kind regards,
Tom
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: ARUBA IAP275 keeps rebooting until Ethernet port is connected
Re: ARUBA IAP275 keeps rebooting until Ethernet port is connected
05-18-2016 03:36 AM
Did you configure the AP as a Standalone?
Colin Joseph
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: ARUBA IAP275 keeps rebooting until Ethernet port is connected
Re: ARUBA IAP275 keeps rebooting until Ethernet port is connected
05-18-2016 04:15 AM
I should have. Is there a way to verify?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
05-18-2016 04:30 AM
Colin Joseph
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: ARUBA IAP275 keeps rebooting until Ethernet port is connected
Re: ARUBA IAP275 keeps rebooting until Ethernet port is connected
05-18-2016 05:29 AM
Just adding this topic too!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator