Controllerless Networks

Reply
Occasional Contributor II

Aruba Instant 207 Site Survey Issue

Hello All,

 

I have a site survey using my Aruba Instant 207 AP, how could i enforce it to work without DHCP, and how to encrease my antinna power to a high power?

Guru Elite

Re: Aruba Instant 207 Site Survey Issue

1.  Convert your IAP to standalone mode:  http://community.arubanetworks.com/t5/Controller-less-WLANs/How-to-convert-IAP-to-Standalone-mode-from-CLI/ta-p/2137092

 

2.  See the detailed instructions in the post here:  http://community.arubanetworks.com/t5/forums/v3_1/forumtopicpage/board-id/unified-wired-wireless-access/page/2/thread-id/549#M62597



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II

Re: Aruba Instant 207 Site Survey Issue

Thanks for quick reply :)

Where could i find (Disable SSID on Uplink failure) it is not appeare on the SSID advanced sitting?

I want to transmit the maximum powre from my access point, what is the limit for 2.4 and 5 GHz and from where could i change it?

Guru Elite

Re: Aruba Instant 207 Site Survey Issue

What version of InstantOS are you running?

You set the Power under RF> ARM.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II

Re: Aruba Instant 207 Site Survey Issue

IAP 207 Firmware : 6.5.1.0 - 4.3.1.0

Please view the photos attached which one of them is the right place to change the antinaa power? 

Guru Elite

Re: Aruba Instant 207 Site Survey Issue

min.png



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: