06-26-2014 07:37 AM
So I think I goofed, I was playing around with the IP addressing options for my RAP-109 set up at home, and now I'm unable to log back in to the virtual controller. I originally had it set up to assign IPs through the virtual controller, but then I edited it to assign them through "Network Assigned" (using my ISP modem). Any thoughts on how to reset and get back access?
Solved! Go to Solution.
06-26-2014 07:45 AM
Is your wireless client getting connected and getting an IP address? If yes, try browsing to https://instant:4343/ . How about connecting to one of the wire ports?
If the client is not getting an IP address your service provider might be limiting the number of addresses it hands out. I think mine limits me to 4. If that is the case you might need to connect and reset the unit back to default and re-configure. To reset the unit there is a reset button. Alternatively, if you have another router that can hand out DHCP you might plug your RAP into it, just to get it online, so you can change the settings back to VC assigned.
04-05-2016 12:17 PM
Need help . Please revert as soon as possible.
04-05-2016 01:34 PM
For an IAP, the reset button, which will wipe the configuration is the only way, unfortunately...http://community.arubanetworks.com/t5/Controller-less-WLANs/Where-is-the-reset-button-on-the-IAP-and-how-do-I-reset-the-IAP/ta-p/180980
There was a reset procedure, but for security reasons, it no longer works, and you must reset.
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base