Controllerless Networks

Reply
Occasional Contributor I
Posts: 9
Registered: ‎08-29-2012

Configure Time Manually on IAP 93

can you guys help me out in configuring Time and date manually on my IAP 93 because i put NTP server and time zone and time is not right its 2001 !! My NTP server is pool.ntp.org

Guru Elite
Posts: 21,270
Registered: ‎03-29-2007

Re: Configure Time Manually on IAP 93

Do it from the commandline and SSH or telnet into the IAP:

 

00:24:6c:ca:cb:b0# clock ?
set Set the time and date

 

00:24:6c:ca:cb:b0# clock ?
set     Set the time and date
00:24:6c:ca:cb:b0# clock set ?
<year>     Year
00:24:6c:ca:cb:b0# clock set 2012 ?
<month>     Month
00:24:6c:ca:cb:b0# clock set 2012 9 6 ?
<hour>     Hour
00:24:6c:ca:cb:b0# clock set 2012 9 6 6 ?
<min>     Minutes
00:24:6c:ca:cb:b0# clock set 2012 9 6 6 4 ?
<sec>     Seconds
00:24:6c:ca:cb:b0# clock set 2012 9 6 6 4 

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 9
Registered: ‎08-29-2012

Re: Configure Time Manually on IAP 93

thx for your reply but i think the VC refused the connection through Telnet and SSh gives me this is there an option at the UI to open Telnet?!!

 

Connecting To 172.27.2.57...Could not open connection to the host, on port 23: Connect failed

Retired Employee
Posts: 234
Registered: ‎04-19-2011

Re: Configure Time Manually on IAP 93

In order to enable telnet on the iAP,
1. log into the webUI of the VC
2. click on "Settings"
3. Click on "Show advanced options"
4. Under the "General" tab on the RHS you will see an option "Terminal Access"
5. Click on the drop down and select "Enabled"
6. click OK.

--
HT
Occasional Contributor I
Posts: 9
Registered: ‎08-29-2012

Re: Configure Time Manually on IAP 93

Thank you very Much all done now

Search Airheads
Showing results for 
Search instead for 
Did you mean: