Controllerless Networks

Reply
Occasional Contributor II
Posts: 37
Registered: ‎06-18-2014

Do you know how can i config monitor mode by command line?

Hi all,

 

I would like to know how can i change the AP225 to monitor mode by command line? Perhaps the solution could be in "dot11a-radio-profile" but i don't understand how can i use this comands.

 

After that I would like to know how can i restart it? is ok to use reload for restar it o maybe this comand coulb do a reset?

 

Thanks for all,

 

Xavi

Regular Contributor II
Posts: 220
Registered: ‎10-09-2009

Re: Do you know how can i config monitor mode by command line?

[ Edited ]

Are you talking about spectrum monitoring? You can try using the Aruba Solution Exchange page (https://ase.arubanetworks.com/solutions/id/40). This page walks you through the CLI creation and at the end it gives you the commands with your entries where you can copy and paste it into your configuration.

 

About rebooting, once the configuration is done and saved, just provision the AP you want as a monitor. It will reboot itself to get the new configuration.

MVP
Posts: 4,309
Registered: ‎07-20-2011

Re: Do you know how can i config monitor mode by command line?

The air monitor mode ( am mode ) as you pointed out can be set on the 802.11 radio profile once you do that you need to add that profile to ap group that AP is in but make sure you don't do this to APs that providing access to clients because will disrupt this process
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Search Airheads
Showing results for 
Search instead for 
Did you mean: