Controllerless Networks

Reply
New Contributor
Posts: 4
Registered: ‎04-06-2015

Error status with Instant in Airwave Configuration

Before deploying Aruba across each of our campuses, I want to make sure I get it right. For my initial setup, I have four AP-215s. One of these is configured as the Virtual Controller and it has two SSIDs: Staff and Guest. I have no problem getting these to work if configured from the VC, and it picks up the other APs just fine.

 

When I add the VC to AirWave, it shows up in New Devices. I add it to a group, and if the group is Read+Firmware Updates, the configuration status shows as good. If I set the APs to Manage Read/Write, the APs all show a status of Error. Clicking the link for Error brings me to Group>Virtual Controller>AirWave, but it says there are no mismatches for this cluster. So, it looks like it's not importing the configuration from the VC.

 

So, ok, I go back to the Groups page, pick my group, and choose Modify Devices. I select the Virtual Controller and choose import settings from selected devices (and discard current per-device desired settings) because this option looks like it is supposed to import the config from the device. I click Import Settings and the page reloads with the essage "Import Settings is not applicable to the following devices: Virtual Controller". It does the same for any of the APs that belong to that VC.

 

AMP 8.0.7.1

APs on 6.4.2.3-4.1.2.1_49445

Contributor I
Posts: 33
Registered: ‎07-10-2014

Re: Error status with Instant in Airwave Configuration

The Problem is : 6.4.2.3-4.1.2.1_49445

 

Airwave only support 6.4.2.3-4.1.1.1_xxxxxx

 

Downgrade the image to policy 4.1.1.1 and you are good

New Contributor
Posts: 4
Registered: ‎04-06-2015

Re: Error status with Instant in Airwave Configuration

I downgraded to 6.4.2.0-4.1.1.1_46936 but it does exactly the same thing.

Contributor I
Posts: 33
Registered: ‎07-10-2014

Re: Error status with Instant in Airwave Configuration

Make sure the instant policy version for the group is 4.1.1 

 

 

New Contributor
Posts: 4
Registered: ‎04-06-2015

Re: Error status with Instant in Airwave Configuration

Where can I find this?
Search Airheads
Showing results for 
Search instead for 
Did you mean: