Controllerless Networks

Reply
Occasional Contributor I
Posts: 9
Registered: ‎04-05-2016

How to get Virtual controller on Aruba central to the native vlan

I'm setting up an IAP cluster managed by Aruba Central.  When i get to the part where i configure the Virtual Controller it requires that I put in a VLAN ID that is between 1-4093 excluding 3333.

 

In the scenario i want... the APs would be on a truck with both the APs and the virtual controller on the native vlan.  How do you accomplish this?  Or is this a limitation of Central? I know you can configure the IAP to do this natively.

 

Aruba-Central-Native.PNG

 

 

MVP
Posts: 518
Registered: ‎11-04-2011

Re: How to get Virtual controller on Aruba central to the native vlan

By default, you do not need to set the VC subnet, gateway and VLAN; if it is in the same network as the IPs for the native VLAN. If you want to configure a VC IP to reach the VC always on the same IP, just put in an IP address in the same IP range.

--
If you have urgent issues, please contact your Aruba partner or Aruba TAC (click for contact details).
Occasional Contributor I
Posts: 9
Registered: ‎04-05-2016

Re: How to get Virtual controller on Aruba central to the native vlan

totally worked. Very non-intuitive. As a network engineer if you prompt for a subnet, I'm going to fill it in. Some feedback to the user would be great.
Search Airheads
Showing results for 
Search instead for 
Did you mean: