Controllerless Networks

Reply
Contributor I

How to upgrade an IAP 115 using the cli

How do I upgrade system firmware using the CLI?

Re: How to upgrade an IAP 115 using the cli

Upgrading an Image Using CLI

 

To upgrade an image using a HTTP, TFTP, or FTP URL:

(Instant Access Point)# upgrade-image <ftp/tftp/http-URL>

 

To upgrade an image without rebooting the IAP:

(Instant Access Point)# upgrade-image2-no-reboot <ftp/tftp/http-URL>

 

To view the upgrade information:

(Instant Access Point)# show upgrade info

 

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos
Contributor I

Re: How to upgrade an IAP 115 using the cli

Thanks Seth - this worked great!  Tftp was taking too long so I installed an Apache http server and it was able to upgrade pretty quickly after that.  The Internet connection at this location is not very good and it would fail to upgrade when using the GUI.

New Contributor

Re: How to upgrade an IAP 115 using the cli

 Can i use the same commands for an ap225? I'm adding an ap225 to a virtual controller (ap135). 

Guru Elite

Re: How to upgrade an IAP 115 using the cli

Yes.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II

Re: How to upgrade an IAP 115 using the cli

Will the cmd work in apboot mode on a IAP 105? If not, how to upgrade if no DHCP server and not joining to cluster?

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: