Hi I have noticed that the IAP-275 does not accept the APENV commands after interrupting the boot sequence. Is there any reason for this or is this by design.
What are the exact commands you are trying to put in?
Not exactly just any of them.
Anybody know why the commands are not accepted?
The commands work fine, I did it just last week on an IAP-275 with no issue. Are you sure you've loaded the correct driver for the USB within the 275? Getting specific output/console copies of what you are seeing would help.
Thanks for the replies, the IAPs have booted up with the command set working now - I'm not sure what the problem was before.
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.