I began an IAP installation by booting one AP, upgrading the firmware to the latest version I saw (6.2.1.0-3.4.0.0_39086), creating two networks and testing same (one internal and one guest), and changing admin password. I installed the AP in it's final location, so it was rebooted a couple of times following upgrade and configuration; all was well up to this point.
I then put a second AP on the network expecting to simply plug in all additional APs to complete this installation. The second AP is not being found or recognized by the master. Both APs are on the same subnet and, in fact, on the same switch. The second AP I am trying to join to the network has green indicators on power and ethernet, but red indicators on 11a/n and 11/b/g/n.
I have 30 APs total to install and have tried two different APs in addition to the master; both additional APs are behaving the same.
I will appreciate any comments or solutions!