Controllerless Networks

last person joined: yesterday 

Instant Mode - the controllerless Wi-Fi solution that's easy to set up, is loaded with security and smarts, and won't break your budget
Back to discussions
Expand all | Collapse all

IAP225 Over-the-air Mesh

This thread has been viewed 0 times

  • 1.  IAP225 Over-the-air Mesh

    Posted Jan 08, 2016 01:33 PM

    Hi all,

     

    Is it possible to to over-the-air mesh configuration with AP225 on code 6.4.3.4-4.2.1.0 ?

     

    I can do wired first join, but I would like to see if there was a way without first connecting it to the same subnet/vlan as VC.

     

    Thank you.

     

    N



  • 2.  RE: IAP225 Over-the-air Mesh
    Best Answer

    EMPLOYEE
    Posted Jan 08, 2016 03:58 PM

    No, it must join wired first.



  • 3.  RE: IAP225 Over-the-air Mesh

    Posted Mar 10, 2016 11:12 AM

    Hello this is somewhat related to my questions i am trying to figure out if this IAP would be able to handle mesh over a distance of about 175ft?



  • 4.  RE: IAP225 Over-the-air Mesh

    EMPLOYEE
    Posted Mar 10, 2016 01:35 PM

    It's possible, depending on the conditions and setup (AP orientation, channels used, noise floor, environment, etc) and use case/application. Best case would be to test it as we don't do longer range mesh testing on indoor APs. 



  • 5.  RE: IAP225 Over-the-air Mesh

    Posted Mar 10, 2016 02:09 PM

    Thank you for the advice. 



  • 6.  RE: IAP225 Over-the-air Mesh

    EMPLOYEE
    Posted Mar 10, 2016 05:17 PM

    If it's clear line of sight, no interference, no obstructions and both ceiling mounted, throughput should be approx 30-60Mbps HT20, or approx 50-100Mbps for HT40.



  • 7.  RE: IAP225 Over-the-air Mesh

    Posted Mar 10, 2016 05:25 PM

    Ok so what you are saying is I should be able to run these as a mesh with this distance as long as I have them both ceiling mounted and a clear line of sight? I mean I am talking about 5-15Mbps at the high end.



  • 8.  RE: IAP225 Over-the-air Mesh

    EMPLOYEE
    Posted Mar 10, 2016 05:59 PM

    Yes