Hello,
I have a Iap-225 with software version 6.4.4.4-4.2.3.2_54910. I run this version because i wanted to disable the broadcast of the SSID's on specific times.
Im trying to set up my ENET1 port as a bridge port. But when i plug in my laptop on this port it stays down. If i reboot the IAP i can see the port goes up for a short time and then goes down again.
My setup:
So i created a new wired profile (bridge) with the following settings:
Employee
POE: Disabled
Admin status: UP
Under advanced settings:
Content filter disable
Uplink Disabled (tested also with enabled)
On the VLAN page i use Access port.
I tryed both options: virtual controller managed as network assigned
Security tap is default and access tab is unrestricted.
Now this profile is created i bind it to interface 0/1.
I have not tested it with another software version yet. Any Idea?
When i do a show wired-port-settings:
Wired Port Profiles
-------------------
Name VLAN Mode Allowed VLANs Native VLAN Admin Status Role Speed Duplex POE In Use Authentication Method STP
---- --------- ------------- ----------- ------------ ---- ----- ------ --- ------ --------------------- ---
wired-instant Access all guest Up wired-instant auto auto No Yes None No
default_wired_port_profile Trunk all 1 Down default_wired_port_profile auto full No Yes None No
bridge Access all guest Up bridge auto auto No Yes None No
Port Profile Assignments
------------------------
Port Profile Name
---- ------------
0 default_wired_port_profile
1 bridge
2 wired-instant
3 wired-instant
4 wired-instant