Controllerless Networks

Reply
New Contributor

Optimal RF configuration IAP-335

Hi everyone. Hope all is well with you. I was wondering what would be the optimal RF configuration for two IAP-335 deployed in a 4,300 sqft brick apartment. They are connected to a Humax modem through a TP-Link 8p POE+ switch. The modem is connected to the ISP providing 250mb down / 20mb up. Below, it's the current config. Thank you in advance.

Airtime Fairness Mode: preferred Access

ClientMatch Calculating Interval: 3 seconds

ClientMatch Neighbor Matching: 60 %

ClientMatch Threshold: 5

Spectrum Load Balancing Mode: Channel + Radio

Min Transmit Power: 18

Max Transmit Power: Max

Client Aware: On

Scanning: On

Legacy Only: Off

802.11d / 802.11h: On

Beacon Interval: 100 ms

Interference Immunity Level: 2

Channel Switch Announcement Count: 0

Background Spectrum Monitoring: Off

Customize ARM Power Range: Off

Very High Throughput: On

Victor Soares
Aruba Employee

Re: Optimal RF configuration IAP-335

Hard to give advice without understanding a bit more about the RF environment.


Are there any issues or concerns with the wireless access?

 

Take a look at the following for some recommendations/best practices.

 

http://community.arubanetworks.com/t5/Validated-Reference-Design/Aruba-802-11ac-Networks/ta-p/242637

 

It's for Controller based networks but still applicable to the IAP.

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: