Controllerless Networks

Reply
New Contributor
Posts: 2
Registered: ‎02-18-2016

Removing nat from iap

Hi everyone.

I'm using the default dhcp from the IAPs. Is there a way to disable NAT so my firewall sees user's ip adress and not IAP's address incoming?

Thanks.

Guru Elite
Posts: 21,512
Registered: ‎03-29-2007

Re: Removing nat from iap

In the SSID configuration, the VLAN needs to be network assigned instead of "Virtual Controller Assigned".  The VLAN specified would have to be defined on the trunk between your IAPs and your switch, or you can just make it VLAN 1 to make it on the management VLAN of the IAP.

http://www.arubanetworks.com/techdocs/Instant_423_WebHelp/InstantWebHelp.htm#UG_files/WLAN_SSID_conf/ConfiguringVLANSettings.htm?Highlight=virtual controller assigned



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 2
Registered: ‎02-18-2016

Re: Removing nat from iap

[ Edited ]

Ok, that's what I feared.

Thanks for your quick answer.

Search Airheads
Showing results for 
Search instead for 
Did you mean: