02-19-2015 03:03 PM
Would there be any reason why by default under "System" , "Airwave" I would have a predefined configuration such as:
Airwave Server: 184.108.40.206
Shared Key: **********
I have done a "clear configuration" and rebooted the IAP and this setting comes back. I manually remove it. It only comes back when the IAP is rebooted.
IAP Version: 220.127.116.11 (it was 18.104.22.168 and I rolled it back)
I have not dont a "factory_reset" in the CLI yet.
Solved! Go to Solution.
02-19-2015 03:13 PM
The weird thing is if you actually insert that IP address into a browser it brings you to a Airwave server login and whats more weird is that its an IP address coming from Sunnyvale, CA.
Its a little scary because this whole time my IAP was in ?monitor? mode on someone else?s Airwave. I knew I was connected because at the bottom it said ?Airwave: Connected?
02-23-2015 01:45 PM
Late to the show, but just wanted to add that SEEL is demo lab in Aruba HQ. It's possible that your AP came from a collection that was early on provisioned to be used with that setup and then the extra APs were never cleaned out of the system. Tim had it right in guessing that it's a possible Aruba Activate profile that's populating that AP. Support maintains the Aruba Activate site.
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company