You've configured the relevant server settings for your iperf3 server?
Uplink Bandwidth Monitoring
An Instant AP uses Iperf3 as a TCP or UDP client to run a speed test and measure the bandwidth on an uplink.
The results from the speed test are collated by the Instant AP and published to ALE. Speed tests can be run
only on master Instant APs. They cannot be run on slave Instant APs.
Apart from ALE, Instant APs can collate and send speed test information to Central by using Iperf3.
You may choose to configure and execute a speed test profile during boot time and additionally at specific time
intervals using the configuration mode or execute the speed test at any preferred time using the privileged
EXEC mode in the CLI.
To configure and automatically run speed tests at specific time intervals:
(Instant AP)(config)# speed-test
(Instant AP)(speed-test)# include-reverse
(Instant AP)(speed-test)# server-ip <server>
(Instant AP)(speed-test)# server-port <port>
(Instant AP)(speed-test)# on-boot
(Instant AP)(speed-test)# omit
(Instant AP)(speed-test)# protocol <tcp/udp>
(Instant AP)(speed-test)# parallel
(Instant AP)(speed-test)# time-interval <interval>
(Instant AP)(speed-test)# bandwidth <bandwidth>
(Instant AP)(speed-test)# sec-to-measure <secs>
(Instant AP)(speed-test)# window
To configure and execute a speed test at any preferred time:
(Instant AP)(config)# speed-test 10.17.144.8 tcp include-reverse sec-to-measure 10 serverport
5201 parallel 10 omit 1 window 512
To view the speed test results:
(Instant AP)# show speed-test data