Controllerless Networks

Reply
Occasional Contributor II

Where can i enable/disable spectrum load balancing in virtual controller?

Hi,

 

Are there any place in virtual controller to enable/disable the spectrum load balancig? Maybe this mode dosen't exist in the new virtual controller, because it is override by clientmatch, is it right?

 

Thanks for all,

 

 

Re: Where can i enable/disable spectrum load balancing in virtual controller?

IAP# conf t
We now support CLI commit model, please type "commit apply" for configuration to take effect.
IAP (config) # arm
IAP (ARM) # no spectrum-load-balancing

Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Moderator

Re: Where can i enable/disable spectrum load balancing in virtual controller?

Spectrum Load Balancing can also be enabled / disabled in the WebUI.  Click on RF in the upper right-corner then "Show Advanced Options".

 

You are correct, however, in that with ClientMatch enabled SLB will be ignored.

 

 SLB.jpg

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: