I am reluctant to try this change during production hours because the last time I did, my entire Instant network went into a cyclical rebooting (see my previous post). I believe however that the cause of that problem has been eliminated by replacing an AP.
I could try it after hours.
I tried this for another reason which was troubleshooting something similar to:
http://community.arubanetworks.com/t5/Mobile-Device-Configuration-and/Problem-with-HP-thin-client-t5740e-Atheros-AR5009/td-p/41934
I should also mention that I have also customized the 5 ghz channel selection from default values as follows:
Removed Added
149 108
153 116
157 132
161 136
165 140
149+ 108+
157+ 132+
I did this to address another weakness of these particular thin clients, difficulty connection on channels over 140.
I am trying to achieve what was drafted in an RF Plan by my VAR (CDW) Aruba SE. It is based on the following power settings for these APs:
Access Point RF Plan
Name/Location Power (db)
B4 Main Floor 20
B4 Basement 12
B5 Main Floor 20
Pole Barn South 20
B6 Main 12
B6 Lab 20
B7 Mez Upper 12
B7 Break Rm 20
B7 Main Floor 20
B7X Main Floor 20
Receiving Dock 20
B8 Shop 20
B8 Main Floor 20
I am open to suggestions on how to achieve this.