Controllerless Networks

Reply
New Contributor
Posts: 1
Registered: ‎11-28-2013

Why would mesh be disabled on a an IAP-115 running 6.3 code%3F

Hello All,

I have one IAP-224, running as a VC that i want to use as a mesh portal and one IAP-115 which i am trying to setup as a mesh point. If i plug the IAP-115 into the L2 network, it becomes part of the cluster no problem. As soon as i disconnect the ethernet and turn it back on, it elects itself master and finally reboots after about 2 or 3 minutes.

 

Both my IAP-224 and IAP-115 tell me MESH not supported in the mode

 

I had also tried turning on bridging for ethernet 0 but all that really does is bypass teh uplink check and not much else.

 

Anyone have any ideas as to what might be wrong?

Guru Elite
Posts: 8,792
Registered: ‎09-08-2010

Re: Why would mesh be disabled on a an IAP-115 running 6.3 code%3F

Mesh is not currently supported on 11ac access points.

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Moderator
Posts: 681
Registered: ‎04-16-2009

Re: Why would mesh be disabled on a an IAP-115 running 6.3 code%3F

As cappalli mentioned Mesh is not supported on the IAP-22x till later this year.

 

Also, for the IAP-115 to join a Mesh you need to make sure "Extended SSID" is disabled.   This is found under System ->Advanced Options.

Search Airheads
Showing results for 
Search instead for 
Did you mean: