12-23-2015 01:55 AM
Is there a way to make the number of lines shown with show ap debug auth-trace-buf higher?
Or can i somehow log these lines to an external server? I have set all categories to debug for syslog, but don't see it.
Anything else possible?
It is a useful command, but in a busy enviroment it becomes difficult to get the transaction from the client you are looking for.
Solved! Go to Solution.
12-23-2015 03:57 AM
You cannot limit the number of lines, or send it to syslog but if you turn on user debug only for a few specific clients, the output will only be limited to those clients:
(Aruba7005-US) #configure t Enter Configuration commands, one per line. End with CNTL/Z (Aruba7005-US) (config) #logging level debugging user-debug de:ad:be:ef:ca:fe (Aruba7005-US) (config) #show debug DEBUG LEVELS ------------ Facility Level Debug Value Sub Category Process -------- ----- ----------- ------------ ------- user-debug debugging de:ad:be:ef:ca:fe N/A N/A (Aruba7005-US) (config) #exit (Aruba7005-US) #show auth-tracebuf Warning: user-debug is enabled on one or more specific MAC addresses; only those MAC addresses appear in the trace buffer.
You would then use something like airrecorder to periodically collect the output of show auth-tracebuf.
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base
12-24-2015 02:21 AM
thanks cjoseph, this is about Instant so i believe the logging level user-debug isn't possible? it just collects it for everyone?
ill look into the airrecorder, sounds useful.
12-24-2015 04:16 AM