Controllerless Networks

Reply
Occasional Contributor II

powersave DOS attack message

Hi,

 

I am seeing the lot of power save dos attack messages on the controller. In the ids-dos profile power save dos attack is enabled.

 

Could anyone let me know how to avoid these messages on the controller without disabling the power save dos attack in ids profile?

 

Can we ignore this message? please be informed that there is no impact seen on the network.

 

Thanks.

Guru Elite

Re: powersave DOS attack message

It depends on the version of code you are running.  There was a bug fixed in 6.1.3.2 where we misinterpreted certain frames as a powersave DOS attack.  


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Occasional Contributor II

Re: powersave DOS attack message

Would this affect version 6.1.2.7?

Guru Elite

Re: powersave DOS attack message

yes


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Occasional Contributor II

Re: powersave DOS attack message

Thanks CJ,

Could you please let me know the correct recommended values In ids profile for the power save does attack?
Guru Elite

Re: powersave DOS attack message

The defaults should be fine.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: