Location Services

-- ArubaOS 6.1.3.7_37112
-- vim:set ts=4 sw=4:
   WLSX-SWITCH-MIB DEFINITIONS ::= BEGIN
............

requires some pre-req's loaded, a couple of which I cannot find. Most were in the MIBs with the 6.1.3.7 version downloads, but not all. The last two here I cannot find. (Using InterMapper Probe Building to construct the probe)

 

You must import the following MIBs before importing the probe file.

   SNMPv2-TC
   SNMPv2-SMI
   SNMPv2-TC
   SNMPv2-CONF
   ARUBA-MIB
   WLSX-SWITCH-MIB

Hi,

Found it in google - let me know if it's fitted your AOS:

 

http://www.observium.org/svn/observer/trunk/mibs/WLSX-SWITCH-MIB

Aruba Mibs / Standard MIBS attached to this post.

 

more info links: (extranl - not realted to Aruba)

http://www.circitor.fr/Mibs/Mibs

http://community-downloads.quest.com/management-extensions/htm/Aruba_description.htm

 

Interestingly, but not funny, I applied this to two controllers (InterMapper) and the first gave me TONS of information while the second gives me nothing (literally, nothing). Check that both 3400's are running 6.1.3.7 and have the correct SNMP settings.

Same probe against the same code and SNMP the same. What might I be missing?

 

A. did u configured both controllers the same (any traps on anyting? )

B. both of them are masters?

Master, yes. Traps, no. Inherited, but have gone through a side by side comparision and not seeing any differences. (though I am obviously missing something)

 

do some screenshots of the config in both masters and copy them to here .. i will take a look (snmp configuration)

Found the problem. Not the Aruba. Probe reader /  user error. Have to close and reopen the status window, cannot just refresh.  Oddly, that worked on the first one.

Thanks again, saved me hours I'm sure!!!

 

Good to hear issue solved - have a lovely day.