Monitoring, Management & Location Tracking

Error Message: "Error in SNMP polling: Timeout"

Issue: Error Message: "Error in SNMP polling: Timeout"

 

In the event log on a controller's monitoring page, the message "Error in SNMP polling: Timeout" is a symptom of the controller not responding to any single request from AirWave for snmp data.

If these messages correspond to other problems, like gaps in user/bandwidth graphs, then you can improve the situation by increasing snmp retries on the Device Setup -> Communication page. 4 retries is a reasonable starting point.

Version History
Revision #:
1 of 1
Last update:
‎06-27-2014 05:35 PM
 
Labels (1)
Contributors
Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.