Monitoring, Management & Location Tracking

How to enable controllers to send UCC data to Airwave

Aruba Employee

Airwave 8.0.x  has a new feature, which shows the UCC (lync call info), under home --> UCC tab. for this option to work, we need to have Airwave code 8.0 + and AOS 6.4 +

 

Environment : Airwave monitoring/Managing AOS devices only.

 

1. We need to enable the below option from AMP setup --> general page:, on airwave.

 

rtaImage.png

2. we need to make sure, we add Airwave as a mgmt-server on the controller, as shown below:

for example:

(Controller) #show running-config | begin mgmt-server
Building Configuration...
mgmt-server type amp primary-server 192.x.x.x profile default-amp

so, that the controller can send the AMON information to Airwave without any issues.

please find the command below to add Airwave as a mgmt.-server on the controller

# configure terminal
(config)# mgmt.-server type amp primary-server <ip address> profile  <profile name>

the default profiles available on controllers are below:
default-ale
default-amp

we could see the default profiles by doing the following:

# show mgmt-server profile ?

Mgmt Config profile List
------------------------
Name         References  Profile Status
----         ----------  --------------
default-ale  0           Predefined (editable)
default-amp  0           Predefined (editable)

Total:2

 

1.  We need to make sure if the AMON port is allowed between the controller and airwave, UDP port 8211
2.  need to confirm in the controller profile for mgmt-server, UCC Monitoring is enabled, as by default it will be disabled.

#show mgmt-server profile default-amp

Mgmt Config profile "default-amp" (Predefined (editable))
---------------------------------------------------------
Parameter       Value
---------       -----
Stats           Enabled
Tag             Enabled
Sessions        Enabled
Monitored Info  Disabled
Misc            Enabled
Location        Enabled
UCC Monitoring  Disabled
AirGroup Info   Disabled

we need to manually enable it by doing this:

 #configure t
Enter Configuration commands, one per line. End with CNTL/Z

 (config) #mgmt-server profile default-amp
 (Mgmt Config profile "default-amp") #uccmonitoring-enable
 (Mgmt Config profile "default-amp") #exit
 (config) #show mgmt-server profile default-amp

Mgmt Config profile "default-amp" (Predefined (changed))
--------------------------------------------------------
Parameter       Value
---------       -----
Stats           Enabled
Tag             Enabled
Sessions        Enabled
Monitored Info  Disabled
Misc            Enabled
Location        Enabled
UCC Monitoring  Enabled
AirGroup Info   Disabled

Version history
Revision #:
1 of 1
Last update:
‎11-04-2014 12:17 PM
Updated by:
 
Labels (1)
Contributors
Comments
MRodden

Is there a method to enable UCC data to AMP in an IAP environemnt?

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.