Monitoring, Management & Location Tracking

Reset VisualRF in AirWave 8.0.x.x version

Introduction- If the VisualRF data has become corrupted and VisualRF will not run, here are the steps to reset it:

Environment- The steps given below have been tested and validated for AirWave 8.0.x.x versions.

Answer- 

  • Login to the CLI of AMP via SSH.
  • Navigate to mercury directory. 

                    #cd /root/svn/mercury

  • Disable the AMP.

                    #amp_disable

  • Disable VisualRF. 

                    #dbc "update seas_config set visualrf_enabled = 0;"

  • Bootstrap VisualRF. 

                    #bootstrap_vrf_db
                    #bootstrap_vrf_redis

  • Enable AMP. 

                    #rm –rf /etc/amp_disabled

  • Enable VisualRF. 

                    #dbc "update seas_config set visualrf_enabled = 1;"
 
Now the VisualRF has been reset, login to the GUI of AMP to confirm the same.

 

Verification- After running the above steps, login to the GUI of AMP to find VisualRF module reset to factory settings.

 

Version History
Revision #:
1 of 1
Last update:
‎04-05-2015 02:37 AM
Updated by:
 
Labels (1)
Contributors
Search Airheads
Showing results for 
Search instead for 
Did you mean: 
Is this a frequent problem?

Request an official Aruba knowledge base article to be written by our experts.