Network Management

Reply
Occasional Contributor II
Posts: 17
Registered: ‎01-11-2016

AMP 2nd network Device settings not being saved

I am installing AMP 8.2.2 for a customer and he would like to add the 2nd Network device and the NTP servers.  Under AMP Setup \ Network - I enable the 2nd NIC capability enter in the IP information, then enter in the NTP information, hit save and the informatin is not saved.

 

Any suggestions?

Guru Elite
Posts: 20,993
Registered: ‎03-29-2007

Re: AMP 2nd network Device settings not being saved

Why are you using a second NIC?



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 17
Registered: ‎01-11-2016

Re: AMP 2nd network Device settings not being saved

The end user has one network for internal access (primary network device) and another network for remote access (secondary device).  and while I have you is the name entered for DNS case sensitive?

Search Airheads
Showing results for 
Search instead for 
Did you mean: