Network Management

Reply
Moderator

Re: AirWave 8.2.4 NO CLI


@Jafa1995 wrote:

We would like to configure NIC bonding but it seems the only method is to request TAC assistance.


In 8.2.6.1, NIC bonding can be configured from the AMPCLI -> Enter Commands:

 

$ help ether
ethernet_bonding <ip> <netmask> <gateway>
Enable ethernet bonding of two network interfaces.
If just 'ethernet_bonding' you will be prompted for the 3 IP addresses.

 

You can only bond 1 pair.

 


Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company
Contributor I

Re: AirWave 8.2.4 NO CLI

Is there any update to this on 8.2.6? I have over 20k alerts that came in before I was able to delete the default alert rule. I used to be able to clean these up with alert_cleanup.pl but am now stuck in the sandbox.

Highlighted
Moderator

Re: AirWave 8.2.4 NO CLI

@gosse

 

Open a support case, support will get into the support acct and run the script.


Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: