Network Management

last person joined: yesterday 

Keep an informative eye on your network with HPE Aruba Networking network management solutions
Back to discussions
Expand all | Collapse all

AirWave Template mismatch in Aruba Instant VC for cp-logo-checksum

This thread has been viewed 8 times

  • 1.  AirWave Template mismatch in Aruba Instant VC for cp-logo-checksum

    Posted Oct 18, 2016 04:05 PM

    Hi All,

     

    I have a template mismatch that I can't seem to get rid of. It's always the cp-logo-checksum. I have fetched the new template from the IAP VC multiple times and applied all changes but the mismatch always appears. 

     

    2016-10-18_150220.png

     

    I have also verified that the the:

     

    • captive_portal_cert_checksum
    • captive_portal_logo_checksum

    variables are all correctly in the template.

     

    Has anyone seen this before?

     

    N



  • 2.  RE: AirWave Template mismatch in Aruba Instant VC for cp-logo-checksum
    Best Answer

    EMPLOYEE
    Posted Oct 20, 2016 11:26 AM

    Hi,

     

    The captive logo config is controlled at group level and not per VC/AP level. Thus, we need to go to Group->Basic page to select the captive portal logo image that we want to use. The image needs to be
    pre-uploaded to AMP in 'Device Setup'->'Upload Firmware & Files'->'Captive Portal Logo Files'. Also, please make sure the image is less than 16k.

     

    Regards,

    Vishnu



  • 3.  RE: AirWave Template mismatch in Aruba Instant VC for cp-logo-checksum

    Posted Nov 15, 2016 02:38 PM

    Finally getting back to this. This worked perfectly. Thank you.