Network Management

Reply
Occasional Contributor II

Airwave Configuration API

My question is similar to this post.

 

I am looking to perform some management tasks via the API to Airwave.  I have found where you can pull statics and rename VisualRF campus through it but I cannot seem to locate any documentation around any other configuration tasks.  I did find mention of "New Configuration API" was introduced in 8.0.6 but no info around what this actually means.

 

Release Notes for 8.0.10, top of page 15.

  

Specifically, I am looking to move APs/VCs from one configuration group to another via an automated process rather than logging in and clicking around a lot.  Is this possible?

 

I did also go looking in the documentation link within Airwave but I am running the Dell versions and don’t seem to have the same links.

 

Thank you.

Aruba Employee

Re: Airwave Configuration API

I have attached the API document for your reference. Hope its helpful.


Regards,

Vishnu

Regards,
Vishnu
If my post helped you, don't forget to give kudos ;)
Occasional Contributor II

Re: Airwave Configuration API

That is very helpful.

 

Is it safe to assume if a feature isnt in that guide it doesnt exist?  I dont see any info about how to move APs/VCs from one group to another.  I see how to pull the AP detail but not to make a move.  

 

Thank you for the help and info.

Aruba Employee

Re: Airwave Configuration API

Currently i dont see an option to move the devices from one group to another using API. It would be a good feature request.


Regards,

Vishnu

Regards,
Vishnu
If my post helped you, don't forget to give kudos ;)
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: