Network Management

Reply

Airwave Controller Error Mismatch

Hi,

in Airwave I'm getting the following error

Error.PNG

then when i click on it i get this message

Error 2.PNG

i have no firewall between Airwave and this controller, i have checked the password and the community and there are true.

i have also other controllers , that work fine with the same configuration

 

 

I can't find the cause of this issue any help

 

Regards


Raouf CHAHBOUNE
ICT Network & Security Engineer
CCNP R/S | CCNA Security | ACMP|ACCP|ACDX



[If my post is helpful please give kudos, or mark as solved if it answers your post.]
Contributor II

Re: Airwave Controller Error Mismatch

Hi,

 

Had that problem earlier today. In my case it was a firewall policy blocking SSH towards controllers. Hope it helps.

 

Alan 

Kind regards,
AlanFord
Contributor II

Re: Airwave Controller Error Mismatch

Sorry, just saw FW comment :-(
Kind regards,
AlanFord
Contributor II

Re: Airwave Controller Error Mismatch

Hi Raouf,

 

Just a quick one. Had a chat with TAC guys, and issues in my case was that SSH executed commands were not having enough time to run due to lag on LAN. Fix was to extend time allowed to 30sec (under Device Setup -> Communication). Hope it will help you as well.

 

Telnet/SSH Settings
Telnet/SSH Timeout (3-120 sec):

Alan

Kind regards,
AlanFord

Re: Airwave Controller Error Mismatch

thank you flolks,

Alan , your proposition solved the problem

Regards


Raouf CHAHBOUNE
ICT Network & Security Engineer
CCNP R/S | CCNA Security | ACMP|ACCP|ACDX



[If my post is helpful please give kudos, or mark as solved if it answers your post.]