Network Management

Reply
New Contributor

Airwave - Customize VisualRF Heatmap Signal Cutoff

Hi.

 

One of our customers wants to use the "AP Overlays" Heatmap of Airwave VisualRF and change the "Signal Cutoff" to "-60 dBm".

There is a drop-down menu where i can only choose beetween "-45, -55, -65, -75, -85 and -95 dBm".

Change to another value has no effect.

 

Is there a way to modify this to have a cutoff at -60dBm?

 

Regards, Marco

Re: Airwave - Customize VisualRF Heatmap Signal Cutoff

Hi,

We can not edit singal cutoff value to 60, so changing cutoff value not reflecting any change in heatmaps?

 

If yes then you need to look in to floor size, if gridsize is large then changing cutoff value does not help, try resize the floor and check the status.

 

Regards,
Pavan
If my post address your queries, give kudos and accept as solution!
New Contributor

Re: Airwave - Customize VisualRF Heatmap Signal Cutoff

Hi.

 

Oh no, i expressed myself wrong ;)

 

Changing the cutoff reflecting changes in heatmaps.

From -0 till -54 go to -> -45dBm (red)

From -55 till -64 go to -> -55dBm (orange)

From -65 till -74 go to -> -65dBm (green)

etc.

 

So, it is not possible to set the cutoff value individual? OK.

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: