Network Management

Reply
Occasional Contributor I

Airwave generate report on source and destination ports

Hi everyone,

 

Is it possible to generate a custom report in Airwaves 8.2.1.1 to capture similar information (Source and destination ports) like the cli command on controllers

 

 

show datapath session table

 TYIA

 

Re: Airwave generate report on source and destination ports

Hi,

 

It is not possbile to run report based on port in Airwave.

 

Regards,

Pavan

Regards,
Pavan
If my post address your queries, give kudos and accept as solution!
Moderator

Re: Airwave generate report on source and destination ports

While you can't do it currently, it'd be a great feature request to submit into the innovation portal.


Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company
Occasional Contributor I

Re: Airwave generate report on source and destination ports


@rginRob Gin wrote:

While you can't do it currently, it'd be a great feature request to submit into the innovation portal.


This is very true.

 

Using source NAT means we have, as far as I can see, a very difficult task tracing back to users 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: