Network Management

Reply
Frequent Contributor I

Airwave keeps complaining about configure mis-match for a Virtual Controller cluster.

I have a 3-IAP (2-IAP215 with 1-IAP109) cluster managed on Airwave (v8.0.6.3). Periodically, Airwave will complain of mismatch for the cluster, like below. (I normally just click Repair to kick it away but several times a day is really annoying) 

22.png

However I do not see any mismatch configuration under Instant Config-> AirWave->Mismatches.

 

If I go to Instant Config-> AirWave->Config History, I can see following.

1.PNG

So now, I would like to understand more about why it keeps complaining? Should I turn on auto-repair mode? If so, how to modify the group to do so?

 

Thanks,

/S

 

Aruba Employee

Re: Airwave keeps complaining about configure mis-match for a Virtual Controller cluster.

Please check Rapids Containment Options->if enabled Manage rogue AP containment? if yes, that is reason why airwave->monitor page display mismatch but can't find any thing in IGC->mismatch. dev is coding to fix this, aims to fix this in future release 8.0.7.
Frequent Contributor I

Re: Airwave keeps complaining about configure mis-match for a Virtual Controller cluster.

That is the case for my setup.

 

Do you have an ETA for the fix?

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: