Network Management

Frequent Contributor II
Posts: 184
Registered: ‎04-17-2013

Airwave visualrf incorrect client location



I mapped floor plan into Airwave --> visualrf

As i saw, it's showing incorrect client location in the floor plan.


Kindly suggest resolution


Thank you...

Aruba Employee
Posts: 512
Registered: ‎02-19-2015

Re: Airwave visualrf incorrect client location

client location in visualrf depends up on floor plan size, number of APs hearing that parituclar client. please follow below steps

  • Make sure, while uploading the floor plan , set proper floor size if it is jpeg or pdf file
  • If it is dwg file visualrf automatially take the floor size values
  • Draw regions on floor where APs beeen provisioned and also exteriror walls
  • If only one AP hearing the client then we wont see accurate client location, at least three APs should hear that particular client with good signal strength.




if my post address your quesitons, accept as solution and give kudos:)



Search Airheads
Showing results for 
Search instead for 
Did you mean: