Network Management

last person joined: 14 hours ago 

Keep an informative eye on your network with HPE Aruba Networking network management solutions
Back to discussions
Expand all | Collapse all

Connection Between Controller and AP

This thread has been viewed 1 times

  • 1.  Connection Between Controller and AP

    Posted Dec 11, 2017 04:14 PM

    Hello good afternoon to the whole community, I have a small problem with my laboratory and I'm doing an installation in my network of a 620 controller and an AP 105, the controller configuration is checked and it is good to connect the AP it takes it as an air monitor and will not let me out of that state. I tried restarting the AP but in turn it keeps giving me the same error. Someone here will have an idea why I have this problem?



  • 2.  RE: Connection Between Controller and AP

    EMPLOYEE
    Posted Dec 13, 2017 06:24 PM

    The radio mode is maintained by the radio profile.  So you need to drill down into config -> ap config -> ap group -> RF mgmt -> select radio profile -> set mode to ap-mode instead of am-mode.

    2017_12_13-903.jpg