Network Management

Reply
Occasional Contributor II
Posts: 18
Registered: ‎02-02-2012

Error fetching configuration with Airwave from Cisco switches when telnet is disabled

Hello, 

 

I just noticed that if you disable telnet access in Cisco switches Airwave can't fetch the running configuration. I've looked around but i can't find any setting to force ssh or disable telnet when doing the fetching. Is this a feature or a bug? Shouldn't the default way to communicate be ssh and telnet be just in case ssh fails?

 

Or is it some setting i'm missing?

 

/Tomas

 

Guru Elite
Posts: 21,022
Registered: ‎03-29-2007

Re: Error fetching configuration with Airwave from Cisco switches when telnet is disabled

It should be in the "Groups" setting.

 

Go to :  https://<ip address of airwave box>/static/UserGuide/UserGuide.htm#AWUserGuide/Chapter3_Groups/Configuring_Basic_Group_S.htm



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 18
Registered: ‎02-02-2012

Re: Error fetching configuration with Airwave from Cisco switches when telnet is disabled

Thanks, i was looking under Device setup.

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: