Network Management

last person joined: 21 hours ago 

Keep an informative eye on your network with HPE Aruba Networking network management solutions
Back to discussions
Expand all | Collapse all

How to push config from Airwave to IAP with different subnet

This thread has been viewed 0 times

  • 1.  How to push config from Airwave to IAP with different subnet

    Posted Apr 28, 2015 11:03 PM

    We are having problem pushing config from Airwave to IAP.

    we already join the IAP to Airwave and already assigned to a group but when we create the SSID it does not push to the IAP

    take note that the Airwave is in different subnet of where to IAP is connected



  • 2.  RE: How to push config from Airwave to IAP with different subnet

    Posted Apr 28, 2015 11:57 PM

    Are you using Instant GUI Config or Templates?

    It should not matter if the IAP is on a different subnet than AirWave.   If using IGC, when you made your network/SSID configuration changes in AirWave, did you select "Finish" or "Finish and Apply"?      Does your Virtual Controller show a mismatch?

     

    amp-iap-apply-all.png

     

     



  • 3.  RE: How to push config from Airwave to IAP with different subnet

    Posted Apr 29, 2015 12:59 AM

    Thanks for the reply

     

    We are using the Instant GUI Config in Airwave and after we set up the SSID we click Finish and Apply

     

    but still it does not broadcast the SSID  



  • 4.  RE: How to push config from Airwave to IAP with different subnet

    Posted Apr 29, 2015 07:57 AM

    What icon is next to the VC in Instant GUI Config?  There are 4 possible.   Up, down, mismatch, and processing.

     

    Also, take a look at the Config History tab for that VC under the Instant GUI Config.