Network Management

Reply
New Contributor
Posts: 2
Registered: ‎04-06-2015

How to push config from Airwave to IAP with different subnet

We are having problem pushing config from Airwave to IAP.

we already join the IAP to Airwave and already assigned to a group but when we create the SSID it does not push to the IAP

take note that the Airwave is in different subnet of where to IAP is connected

Aruba
Posts: 1,643
Registered: ‎04-13-2009

Re: How to push config from Airwave to IAP with different subnet

Are you using Instant GUI Config or Templates?

It should not matter if the IAP is on a different subnet than AirWave.   If using IGC, when you made your network/SSID configuration changes in AirWave, did you select "Finish" or "Finish and Apply"?      Does your Virtual Controller show a mismatch?

 

amp-iap-apply-all.png

 

 

------------------------------------------------
Systems Engineer, Northeast USA
ACCX | ACDX | ACMX

New Contributor
Posts: 2
Registered: ‎04-06-2015

Re: How to push config from Airwave to IAP with different subnet

Thanks for the reply

 

We are using the Instant GUI Config in Airwave and after we set up the SSID we click Finish and Apply

 

but still it does not broadcast the SSID  

Aruba
Posts: 1,643
Registered: ‎04-13-2009

Re: How to push config from Airwave to IAP with different subnet

What icon is next to the VC in Instant GUI Config?  There are 4 possible.   Up, down, mismatch, and processing.

 

Also, take a look at the Config History tab for that VC under the Instant GUI Config.

------------------------------------------------
Systems Engineer, Northeast USA
ACCX | ACDX | ACMX

Search Airheads
Showing results for 
Search instead for 
Did you mean: