Network Management

Reply
New Contributor

Installation and Config of SNMP Client for External Monitoring of Airwave Server

Hello Everyone,

 

Wondering if i could gather some help with regards to monitoring Airwave.

 

We have a monitoring service that needs to poll the airwave system for monitoring with UP/Down Icmp and SNMP monitoring. However I can't seem to get this to work.

 

What is the initial setup of this.

 

I have access to the Airwave server but hot the host server.

 

I can access via SSH command line and the GUI but no other way.

 

How would I go about setting up an snmp client on the Airwave system?

 

Kind Regards,

 

James

 

Aruba Employee

Re: Installation and Config of SNMP Client for External Monitoring of Airwave Server

Hi James,

 

You want to montior the UP/Down status of Airwave server or devices which Airwave montioring through exteranal NMS server?

 

We have triggers for APs device down/up and  system resources trigger for CPU and memory utilization in system>trigger page. We could set trigger condition and export to external NMS server.

 

In AMP Setup -> NMS, download the AMP MIBs and upload them into your external SNMP, and then assign the proper reaction from your external SNMP.

 

Regards,

Pavan

New Contributor

Re: Installation and Config of SNMP Client for External Monitoring of Airwave Server

Hi Pavon,

 

No nothing to do with the AP's at this point.

 

I purely want to monitor the Airwave server and its services/resource.

 

So I would be looking to monitor without the use of Traps.

 

CPU

Memory

Disk Space

Network Interfaces

etc, etc

 

So its purely our NMS > Poller > Airwave monitoring. Not Airwaive to NMS.

 

We need to be able to poll airwave from an SNMP Monitoring tool.

Aruba Employee

Re: Installation and Config of SNMP Client for External Monitoring of Airwave Server

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: