Network Management

Reply
Occasional Contributor II
Posts: 22
Registered: ‎11-06-2013

Monitoring IAP-105's via SNMP shows all Radios as "Null Traffic" How can I pass the names via SNMP?

Monitoring IAP-105's via SNMP shows all Radios as "Null Traffic"  How can I pass the names via SNMP?

See screenshot, SNMP call pulls all info from the Virtual Controller.  But the radio's show as "Null Traffic" "MAC layer over Radio Links"  within the Controller though I have the WAPs named.

Guru Elite
Posts: 20,396
Registered: ‎03-29-2007

Re: Monitoring IAP-105's via SNMP shows all Radios as "Null Traffic" How can I pass the n

Are you using the Aruba Mibs to monitor the traffic? http://support.arubanetworks.com/LifetimeWarrantySoftware/tabid/121/DMXModule/661/Default.aspx?EntryId=20377



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 22
Registered: ‎11-06-2013

Re: Monitoring IAP-105's via SNMP shows all Radios as "Null Traffic" How can I pass the n

I haven't tried this, I was just using the snmp sensor built-into PRTG network mon...

So I've tried Paessler MIB Importer, and downloaded what I think is the MIB for the IAP-105's (orion) in the link you sent:  http://support.arubanetworks.com/LifetimeWarrantySoftware/tabid/121/DMXModule/661/Default.aspx?EntryId=20377

 

But I can't see to get it to import (parse error).

 

suggestions?

 

Occasional Contributor II
Posts: 22
Registered: ‎11-06-2013

Re: Monitoring IAP-105's via SNMP shows all Radios as "Null Traffic" How can I pass the n

So I've tried Paessler MIB Importer, and downloaded what I think is the MIB for the IAP-105's (orion) in the link you sent:  http://support.arubanetworks.com/LifetimeWarrantySoftware/tabid/121/DMXModule/661/Default.aspx?EntryId=20377

 

But I can't see to get it to import (parse error).

 

suggestions?

Occasional Contributor II
Posts: 22
Registered: ‎11-06-2013

Re: Monitoring IAP-105's via SNMP shows all Radios as "Null Traffic" How can I pass the n

I have the Aruba MIBs downloaded, and I'm trying to import the correct ones into PRTG.  I've converted the "MY" files into the OIDLIB files that PRTG looks for when adding a sensor.... my question now is, which "MY" file should I be using for the IAP-105's, is there one that would contain SSID specific data?

Search Airheads
Showing results for 
Search instead for 
Did you mean: