Network Management

Reply
Contributor II
Posts: 45
Registered: ‎10-11-2013

New AirWave install, Aruba AP's show status DOWN

Getting up and running with a fresh install of AirWave
(There was a previous installation using a different IP address)

 

When adding manually adding Aruba AP's their status shows DOWN
Manually adding other devices is working fine

 

Perhaps my SNMP creds are incorrect? I matched the strings on the controller under CONFIGURATION > MANAGEMENT > SNMP

 

Is there a place to set SNMP per device group or VAP?

 

Thanks

Guru Elite
Posts: 8,335
Registered: ‎09-08-2010

Re: New AirWave install, Aruba AP's show status DOWN

The APs will be discovered through the controller. Is the controller up in AirWave?

Thanks,
Tim

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Contributor II
Posts: 45
Registered: ‎10-11-2013

Re: New AirWave install, Aruba AP's show status DOWN

Re-adding the controllers did the trick! Once I did that everything snapped into place.

 

 

It's worth noting that Airwave interacts with the Aruba AP's via the controller instead of directly

 

Thank you

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: